[Sub-250g] ZOHD Drift (PNF) FPV Pusher Glider 877mm (EPP)

The ZOHD Drift is a super easy, hand-launch slow-fly pusher glider that has been designed specifically for FPV flying. It is extremely stable in flight, but the controls remain very responsive and accurate. Being a pusher prop design gets the prop well away from the ground, and the hands when launching, it also allows the camera an uncluttered viewing angle.

The Drift is very easy to assemble, no glue is required, and the wing and tail boom remain detachable, making for easy transportation. The Drift has a large battery bay for extended flight times, plus a nose camera bay compatible with most FPV, and AIO cameras available today. It also has a dedicated equipment bay for the flight controller, and  GPS unit, etc. The strong EPP foam airframe also benefits from a tough, specially designed H-girder spar for the wing, built-in CF inside the fuselage for enhanced strength, and CF pushrods throughout for precision control.

The empty weight of the Drift is a meager 162g, so it can very easily be kept under the FPV registration threshold of 250g. You will still need though, to check your country's regulations, some do require you to register a model airplane with a camera on even if it is below 250g.

Being Plug-N-Fly (PNF), the Drift is supplied with a 1406-2600KV brushless motor, 30A brushless ESC w/5V 2A BEC, propeller, 2 x 4.3g servos, and 1 x 8g servo. The recommended battery (not supplied) is either a 2S 900~1500mAh or a 3S 800~1100mAh LiPo battery pack.

Features:
• Specifically designed as an extremely tough, and stable flying FPV platform
• AUW is below 250g to reduce the amount of legislation required to operate as an FPV UAV
• Supplied as PNF with motor, ESC, propeller, and servos
• Removable wing and tail boom for easy transportation
• Molded in tough EPP foam with H-girder spar, and CF reinforcement
• Highly accurate CF control system for precision control
• Pusher prop configuration for the perfect FPV experience

Specs:
Type: ZOHD Drift (PNF) FPV Pusher Glider
Wingspan: 877mm (34.52")
Length: 688mm (27.08")
Motor: 1406-2600KV
ESC: 30A brushless w/5V 2A BEC
Prop: 5x3 3-blade
Servo: 2 x 4.3g, 1 x 8g
Materials: High-quality EPP foam and CF
Empty Weight: 162g

Included:
1 x ZOHD Drift airframe
1 x 1406-2600KV brushless motor
1 x 30A ESC w/5V 2A BEC
2 x 9g servo
1 x 5x3 3-blade propeller
1 x Hardware pack

Required:
A 4ch or more transmitter and receiver
FPV gear

3S Setup:
1 x 3S 800~1100mAh LiPo battery pack
1 x 5x3 3-blade prop

2S Setup:
1 x 2S 900~1500mAh LiPo battery pack
1 x 5x5 2-blade prop