Workbench

This is a very neat device for securing your models hatches. This latch is spring loaded so once latched your canopy stays put!

Specs:
Dimensions: 26 x 16 x 8mm + 15mm pin length 
Material: Aluminum

This is a very neat device for securing your models hatches. This latch is spring loaded so once latched your canopy stays put!

Specs:
Dimensions: 23.5 x 13 x 8mm + 8mm pin length
Material: Plastic / Steel

This is a very neat device for securing your models hatches. This latch is spring loaded so once latched your canopy stays put!

Specs:
Dimensions:  26x16x10mm + 10mm pin Length
Material: Plastic / brass

These are used to help route cables and hoses within your models. These anchors are self adhesive and allow you to pass a cable tie through the anchor, then around the cable or hose you wish to hold in position.

Handy for use in both your models and the workshop!

Dimensions: 25 x 25mm 

Self Assembly Pedal Operated Bungee Launch System/Ramp for FPV/Glider and EDF Models - Hand launching models can be a tricky business and most flyers have had it all go wrong for them at some point, this great launch system is easy to transport & field assemble and allows you to launch totally solo with the peace of mind of adequate airspeed every time for a succesful launch, everything you need is included!

Dimensions once Assembled:
Ramp Length - 1060mm
height at rear - 240mm
height at front -  460mm
width of launch rails - 470mm

Material:
Ramp - GF Tubing with Plastic Joiners
Foot Launch System - Ply with surgical rubber hose (2 metres)

WWII Allied Pilot (H68 x W72 x D43mm)

Specs:
Height: 68mm
Width: 72mm
Depth: 43mm
Weight: 31g