Radios

The RadioMaster RP V2 series of receivers now have a built-in TCXO (Temperature-Compensated Xtal Oscillator). The TCXO ensures high stability and accuracy in frequency control and compensates for temperature variations. This results in consistent and reliable signal reception, even in extreme temperature conditions. It also reduces frequency drift over time, providing long-term frequency stability and preventing signal degradation. This provides a superior performance in demanding environments and enhances the flight experiences.

The RP2 2.4GHz ELRS Nano receivers use the high-performance, revolutionary ExpressLRS open-source system. The Nano receivers were designed by the ExpressLRS development team, and feature the ESP8285 MCU and SX1280 RF chips. WiFi is built-in so that you can easily upgrade the firmware and configure the receiver using your PC or mobile phone. Other features of the RP2 V2 are improved solder pads and a super lightweight built-in ceramic antenna.

The RP3 2.4GHz ELRS Nano receivers use the high-performance, revolutionary ExpressLRS open-source system. The ExpressLRS development team designed the Nano receivers, which feature the ESP8285 MCU and SX1280 RF chips. This offers Lora and FLRC 2.4GHz RF links for incredible range and low latency. WiFi is built-in to easily upgrade the firmware and configure the receiver using your PC or mobile phone.

The receiver features a Skyworks SE2431L providing an LNA for improved receiver performance, a PA providing up to 100mW of telemetry performance, and antenna switching for antenna diversity.. The RP3 Nano receiver is available in either an FCC or a European LBT version, please check the specifications below for the supported protocol.

The RP3 2.4GHz ELRS Nano receivers use the high-performance, revolutionary ExpressLRS open-source system. The ExpressLRS development team designed the Nano receivers, which feature the ESP8285 MCU and SX1280 RF chips. This offers Lora and FLRC 2.4GHz RF links for incredible range and low latency. WiFi is built-in to easily upgrade the firmware and configure the receiver using your PC or mobile phone.

The receiver features a Skyworks SE2431L providing an LNA for improved receiver performance, a PA providing up to 100mW of telemetry performance, and antenna switching for antenna diversity.. The RP3 Nano receiver is available in either an FCC or a European LBT version, please check the specifications below for the supported protocol.