Gas/Glow Engines

This superb geared pump by Turnigy is perfect for filling all sizes of models whether large or small and it is suitable for either gas or glow fuels. Very easy to use, just push your electric starter onto the cone and spin it to either fill or empty, switch the valve over on the pump and it will change the direction of flow. The center of the cone also has a 6mm hex which will take the standard helicopter starting shaft.

This pump is extremely well made (much better than the average 12v electric fuel pump), the body is made from CNC metal parts and the internal gears are made of brass, apart from the valve there are only 2 moving parts so looked after it will last a very long time. Supplied with a filling nozzle, hook/loop tape and a clip so that you can make a strap to fit it to your fuel can.

Features:
• Very well made from CNC parts
• Fast fill or drain
• Few moving parts, very little to go wrong
• Use with your own electric starter

Size:
Length: 92mm
Width: 63mm
Height: 50mm (from face of cone to rear of backplate)
Weight: 245g

4 x M3.5 x 152mm Stand-offs

This SH Engines R5 (Medium Cold) glow plug is perfect for .12~.36 size engines using 16~36% nitro fuels.

A strong, flexible, transparent fuel tank that is suitable for most types of RC models. The fuel tank includes a machined metal cap with fuel feed, a flexible fuel feed pipe with clunk weight, and 2 factory-installed machined metal 90° hose attachment nipples. One of these is for filling the tank, and the other is used for pressure or venting. Each fuel tank comes with a Turnigy sticker that includes the capacity of the tank, this can be attached to the tank in a convenient position to remind you of its size. The fuel tank is suitable for use with both gas and nitro fuels.

Accurately drill your propellers for your TP 35cc gas engine with this easy-to-use drilling jig. The jig is CNC machined from aluminum stock and is supplied with a clamping screw to hold the propeller secure whilst drilling.