Sistemas de Potência

Designed with space-saving and light weight in mind to fit into the smallest of drones, Frsky's XM+ Micro Ultra-Light 16 Channel receiver is no lightweight when it comes to performance!

Boasting no less than 16 channels, failsafe and up to 1km range, the XM+ is compatible with FrSky's D16 mode found on Taranis X9D, X9D Plus, X9E, Q X7 and Horus transmitters as well as external modules, so the full programming power of FrSky's operating systems can be at your fingertips.

The Turnigy TGY-WP23 is one of the latest standard size servos that has an aluminum center case which acts as a heatsink and gears made of titanium and steel. This servo has a digital amplifier which helps it achieve an incredible 23kg of holding power and is no slouch in the speed department either with a speed of 0.12sec.

Designed with space-saving and lightweight in mind to fit into the smallest of drones, Frsky's XM Plus Micro Ultra-Light 16-Channel receiver is not lightweight when it comes to performance!

Boasting no less than 16 channels, failsafe, and up to 1km range, the XM Plus is compatible with FrSky's D16 mode found on Taranis X9D, X9D Plus, X9E, Q X7, and Horus transmitters as well as external modules, so the full programming power of FrSky's operating systems can be at your fingertips.

The Turnigy X6B is a 6-channel two-way receiver designed for multi-rotor aircraft. It uses the 2.4GHz AFHDS 2A (Automatic Frequency Hopping Digital System) protocol and has a dual omnidirectional antenna with superior noise reduction techniques for reliable interference-free operation. It’s compact, easy to install, and boasts a rich easy-to-use interface. The X6B supports 6-channel PWM output, standard PPM output, and i-BUS support for up to 18 channels alongside a reliable voltage sensor interface. This is an excellent addition to your Turnigy TGY-i6s, TGY-i10, and Evolution transmitters as well as a number of other AFHDS 2A transmitters such as FS-i10, FS-i8, FS-i6, FS-i6S, FS-i6X, FS-i4, and FS-i4X. An excellent receiver for multi-rotor drones as it is lightweight cuts down on cabling and comes with built-in battery monitoring.

The Corona R6SF 2.4GHz S-FHSS compatible 6Ch receiver is designed for use with Futaba S-FHSS/FHSS 2.4GHz transmitters, such as T4YF/T6J/T6K/T8J/T10J/T14SG/T18MZ & T18SZ air systems or 3PL/T3PRKA/4PLS/T4PX or T4GRS using S-FHSS/FHSS RF protocol.

When working in "Special mode" the R6SF can output up to 8 channels using S.bus to allow greater flexibility in performance as well as a convenient way to reduce the wire count in tight installations.

The Power HD LW-20MG is the latest servo that features an all-aluminum case, copper and aluminum gears, a powerful coreless motor and it pulls up to 20kg-cm of torque at a speed of 0.16s. The standard sized servo is also waterproof making this a great servo for crawlers, 1/8 scale trucks and buggies. It comes black anodized and with laser-etched graphics.

The top of the range, 16 Channel X8R receiver from FrSky with 8 normal PWM outputs and no less than 16 channels on the dedicated S.BUS output. Now supplied with the 2015 firmware to compy with EU regulations.

This is an outstanding receiver for all applications and is perfect for use with the FrSky Horus, X9D and X9E Taranis transmitters, with their built-in XJT Module or any of the D8 systems to take advantage of the new digital Smart Port sensors.

The FrSky Taranis Q X7S is the next step on from the original Taranis Q X7 and comes in a stunning blue case. It also keeps all the cool features of the Taranis Q X7 but adds even more stunning features. It still has all the usual Taranis features in this radio such as Receiver Signal Strength Indicator (RSSI) alerts, Real-time Flight Data Logging and receiver matching.

This receiver was specifically designed by OrangeRx with the FPV racer in mind. Although it is small and ultra-lightweight it has true diversity technology which is especially important for the harsh environment of FPV racing. These racing conditions are far from ideal, low altitude, lots of obstacles, motors, and video transmissions in close quarters, situations where you need a robust reception.

Turnigy T6A-V2 2.4GHz system is an entry level transmitter offering the reliability of the 2.4GHz signal technology and a receiver with 6 channels. This AFHDS transmitter requires a PC to modify any of the channel variables including mixing and servo reversing.

Turnigy T6A-V2 2.4GHz system is an entry-level transmitter offering the reliability of the 2.4GHz signal technology and a receiver with 6 channels. This AFHDS transmitter requires a PC to modify any of the channel variables including mixing and servo reversing.

Turnigy TGY-811 is designed for Gliders and Composite EDFs -  low profile performance, better precision movement and low electric impedance. This low profile servo is also a great choice for retract gear as well as thin wing control surfaces.

Turnigy TGY-813 is designed for Gliders and Composite EDFs -  low profile performance, better precision movement and low electric impedance. This low profile servo is also a great choice for retract gear as well as thin wing control surfaces.

This handy programming box for the OrangeRx R620X to R1220X V3 and RR12RDTS receivers is perfect to have in your toolbox at the flying field in case you want to change the settings without the need for a PC. It has an integrated RF module that allows you to set up the receiver wirelessly or you can use a wired connection. As the RR12RDTS is primarily designed for drones and helicopters this programming box can also be used to adjust the settings of the flight stabilization systems.

FrSky M7-R hall sensor gimbal is specially designed for FPV racing, 3D and acrobatic fixed wing and 3D Heli pilots who are using the FrSky Taranis Q X7/X7S Transmitter. The 45°throttle travel will allow you to achieve a quick throttle response resulting in precision control.

The FrSky RX8R has been upgraded to the PRO version but retains all the old features. The new PRO version has increased precision and lower latency. Its deviation of PWM is reduced to 0.5us, and the delay of PWM output is 9ms less than that of the X8R in high-speed mode. It also has improved anti-interference from the ignition system on combustion engines.

The Turnigy GT5 receiver is perfectly matched to work with the outstanding Turnigy GT5 6CH 2.4GHz AFHDS 2A Surface Radio to provide the most reliable link. Stop changing receivers from model to model and get an extra receiver now.

Após o enorme sucesso do Turnigy Evolution, o Evolution PRO foi projetado com o drone em mente e ainda é incrivelmente compacto para facilitar o transporte de mochila.

After the huge success of the Turnigy Evolution, the engineers at Turnigy listened to customer feedback, went back to the drawing board, and came up with the exciting Turnigy Evolution PRO. As with the Evolution, the Evolution PRO is designed with the drone flier in mind and is still amazingly compact for easy backpack transportation.

Designed to be splash-proof, the HK-GT2 receiver is a great choice for boats, cars on muddy terrain and rainy days. Stop changing receivers from model to model and get an extra receiver now.

The Power HD DSM44 digital servo is a micro servo with digital control electronics and metal gears. Servo horns and associated hardware are included.

The Turnigy GT5 Surface Radio comes with the ever-reliable 6 channel 2.4GHz AFHDS 2A (Automatic Frequency Hopping Digital System) to provide the most reliable link between radio and RC Car or RC Boat. Included in this package is the Turnigy GT5 Receiver with built-in Gyro for the best traction on the track. The ergonomic design fits easily in your hand.

FrSky R9M radio control system is the first FrSky long range system which works in the frequency of 900MHz. The R9M module offers 4 switchable RF power outputs to so you can choose the appropriate power for different flight situations. Compared to another FrSky 2.4GHz long range receiver like the L9R, the R9 receiver has a longer operating range up to 10KM and above. Moreover, the R9 is also a redundancy receiver which can connect to another receiver to ensure the security of your aircraft.

Turnigy metal gear micro servos represent great performance in a small package. Well suited for helicopters and lightweight 3D planes, Metal gear for strength and coreless motors for excellent holding power.

The Turnigy servos are known for their quality and reliability. Each servo is supplied with mounting screws and a variety of servo arms.

This kit comes complete with the FrSky Taranis X-Lite BRACE. There are also red replacement gimbal stick ends in two sizes, short and long, depending on your needs.

The FLYSKY FGr4S receiver uses the new AFHDS 3 protocol (third-generation Automatic Frequency Hopping Digital System). It uses an internal single-antenna for two-way transmission and is compact in size and easy to install. It can output standard PPM and i-BUS signals.

The OrangeRx TX10i is the big cousin to the popular OrangeRx TX6i. It comes with lots of excellent features such as ergonomic styling, Hall effect gimbals, internal antenna and now with 10 channels so you can use more mixes and features than before to give better control over your model (be it a plane/glider, helicopter or multirotor).

Se você está preocupado em arranhar a tela do Evolution PROs ou danificar uma alavanca de controle durante o transporte, esta capa atende a todos os seus requisitos. Ele simplesmente clica na frente do seu controlador para proteger com segurança a tela e gruda. Ele vem em preto ou branco.

Se você está preocupado em arranhar a tela do Evolution PROs ou danificar uma alavanca de controle durante o transporte, esta capa atende a todos os seus requisitos. Ele simplesmente clica na frente do seu controlador para proteger com segurança a tela e gruda. Ele vem em preto ou branco.

Corona DS-560WP is a fantastic standard servo. Comes with excellent features such as it is waterproof, has ball bearings and metal gears. Precise control and minimal dead-band width, they are an excellent choice. An excellent choice for cars and boats.